Senix Outdoor Power Tools puts effective lithium-ion battery technology to work to reduce device startup time to 0.3 seconds, reducing 94% of preparation time on one operation compared to the standard 7-second pull-up process for gas tools. With the example of mowing a 500 square meter lawn, the traditional gas mower makes numerous breaks for refueling, with its working being interrupted 6-8 times an hour, with a total time of 18 minutes, while the Senix LXT series 5.0Ah battery mowed continuously for 120 minutes with 100% single charge completion rate and saved 92% idle time. According to the North American Consumers Association’s 2023 test results, the Senix electric mower travels at a speed of 5.2 km/h, 23% faster than the same gas model, and can cut the work time of 42 minutes to cut the same area, which is equivalent to cutting the weekend yard work time from 3.5 hours to 2.2 hours.
In device switching effectiveness, Senix Outdoor Power Tools’ advanced power management system allows multi-tool coordination, and battery swaps take only 10 seconds. As consumers switch among chainsaws, leaf blowers, and hedges, traditional gas tools require different containers for different types of fuel, and each switch takes about four minutes, while Senix’ 20V universal battery platform increases tool switching effectiveness by 96%. Senix solution took 58 minutes for the three operations of yard trimming, tree and leaf cleaning, and bush molding, whereas gas solution took 127 minutes, cutting the cost by 54%. Its rapid charging technology has the capability to recharge nearly 80% of the power within 40 minutes with a dual battery strategy.
In loadability, Senix Outdoor Power Tools’ TurboBoost mode has the following benefits for dealing with overgrown vegetation. When the resistance of cutting exceeds 35N·m, the instantaneous power of the motor rises from 1200W to 2000W with the cutting efficiency still above 95%, but the range of fluctuation for the torque of the gas machinery under the identical load is ±18%, increasing the rework rate by 12%. One of the user scenarios showed that the Senix saw was 100% successful in one cut when cutting hardwood branches of 8cm diameter, while the gas tool had to be repeated 1.3 times due to power lag and took an additional 23% of operating time. Its intelligent temperature control system controls the operating temperature of the motor at 45 ° C ±2 ° C to avoid thermal shutdown of gas equipment (forced cooling for 5 minutes at every 30 minutes).
As far as the cost of maintenance in terms of time, Senix Outdoor Power Tools requires only 1.2 hours of routine maintenance a year, conserving 82% of idle time compared to quarterly maintenance on gas equipment (6.8 hours a year). The modular design reduces the time of blade replacement from 15 minutes for gas tools to 2 minutes, and the precision of tool calibration is controlled within 0.05mm, 40 times more precise than in the mechanical transmission system. Based on the equipment life cycle, Senix products can save 380 hours of maintenance in 8 years of life cycle, which is equivalent to 16 full weekends. Its IP55 degree of protection will run untroubled under a weather state with a precipitation intensity of 30mm/h, avoiding 72% suspension of unscheduled work because weather conditions became abrupt, and effectively realizing the efficiency revolution of “single completion of weekend garden tasks”.
